Application and Utilisation of Protective Coatings

25.10. - 26.10.2022 for Electronic Assemblies - ONLINE
An electronic module is only suitable for a specific purpose if it guarantees safe function for a defined time.
A large number of modules are installed in the terminal devices without protective coatings and operate fault-free throughout their entire service life. In an increasing number of cases, the module is used with greater electrical sensitivity or even under difficult conditions. The safe function of an assembly is then only ensured by means of a protective coating.

In the German-speaking area, there is only the GfKORR guideline for the application and properties of a protective coating available. The GfKORR working group "Corrosion protection in electronics and micro engineering" produced this guideline in cooperation of designers, producers, coaters and users of electronic construction groups.

The aim of the seminar is to teach the participants about this guideline and the collected knowledge from the working group, so that a comprehensive and fundamental understanding of coatings and their possible applications for the functionality of electronic assemblies is achieved.

Beginn

25.10.2022 — 09:30 Uhr

Ende

26.10.2022 — 16:30 Uhr

Ort

for Electronic Assemblies - ONLINE

Kosten

FED-Mitglieder: 980,00 €
Nichtmitglieder: 980,00 €

Requirements of protective coatings for usw on assemblies
Classification of protective lacquers
Film properties of protective coatings
Impact of the assembly on protective coatings
Surface and preparation prior to protective coating
Application procedures for protective coatings
Handling of protective lacquers
Prevention of typical coating defects
Coating inspection methods
Repair of coated assemblies

Production engineering, quality assurance, process technology, analytics design and construction as well as all users of coated assemblies

ONLINE-EVENT

Dr.-Ing. Helmut Schweigart
Dr. O.K. Wack Chemie GmbH Ingolstadt, Germany
Beth Turner
Electrolube - Leicestershire, United Kingdom
Jens Bürger
ELANTAS Europe GmbH, Hamburg, Germany
Jens Gruse
Stannol GmbH & Co. KG, Velbert, Germany
Gerd Schulze
Nordson B.V., Maastricht, Netherlands
Jens H. Klingel
KC Kunststoff Chemische Produkte GmbH, Friolzheim, Germany



25.10.2022

09:30 a.m. - 17:00 p.m.
Breaks: 11:40 a.m. / 15:20 p.m.
26.10.2022
08:30 a.m. - 16:30 p.m.
Breaks: 10:10 a.m. /11:40 a.m. / 15:20 p.m.




The registration fees include the guidelines for the Utilisation and fabrication of Protective  Coatings for Electronic Assemblies.
Conditions of participation
The receipt of the registration is considered as binding confirmation of the participant. Upon receipt, you will receive confirmation and an invoice for the order due.
Registered participants can cancel in writing free of charge no later than 11 October 2022 After this date 80 % of the participation fee will be charged. In case of absence or cancellation of participation, the full participation fee is to be paid. Furthermore you may nominate a substitute participant.

Jetzt anmelden